Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is my network configuration.ASA5520--------Internet(S2S VPN)-------Cisco 1821----------------------Cisco 3560 (Layer3)10.100.10.x/24 10.131.4.1/29 10.131.4.2/29 ...
I have configured AnyConnect for remote VPN access and everything works fine minus the annoying warning the pops up when connecting. Users pull an IP address from the pool I created, but are unable to access any network resources on the LAN. I have a...
We have multiple sites that have either fiber 20mb d/u or cable 50/10 d/u. Recently we have upgraded our head end router to a 2921 security based router and noticed that no matter if we are sending or receiving the most we can push is 1.6Mb. I would ...
We have 7 remote offices and 10 tower locations that utilize IPsec tunnels back to our HQ. We now want to force all traffic including web surfing through the tunnels. What would be the easiest way to acomplish this? I have tried utilizing the crypto ...
The reason for the double entry is I typed the access list out instead of copying it. My apologies. Here is the packet tracer results and the routes on the asa and the router.DATAC-FW01# packet-tracer input Lan tcp 10.100.10.1 80 192.168.1.4 80Phase:...
Below is the parts of the configure that adhere to this particular site. We have over 30 vpn tunnels on the ASA and with all the network objects it is rather long.ASAroute Lan 192.168.4.0 255.255.255.0 10.131.4.2 !object network OF_LIGO_192 subnet 1...
The router and Asa both do nat to protect the networks behind them. I have placed the networks on the 3560 in the acl on the router and on the Asa along with putting the static route in.Any thoughts? I can attach configs if that would help.Sent from ...
The internal LAN uses the ASA as the default gateway. With it being configured like that would I not just use access lists to allow traffic between the two networks?
I guess I should verify stuff before I post.I did a show ip cef and it shows all of my tunnel addresses. I then ran a sh cef int tun 0 and it shows the following. Corresponding hwidb fast_if_number 8 Corresponding hwidb firstsw->if_number 8 Inter...
