Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am very confused on how I setup a Pix 515 that I just got to route traffic out a cable modem. First, let me give you a little details on my current network setup and what I am trying to accomplish with this Pix 515. Currently all my users go out th...
Okay.. For the last two days right at 4:55pm and 5:00pm our management vlan has gone down. Only affecting that vlan. LMS 2.6 network view shows dashes red lines to all devices.. Whats up gold starts sending off massive alerts cause it can't see anyth...
We hav to renew our smartnet and I was just wondering if there is anyway to use LMS to get the serial numbers of the device I currently have in the DCR?Thanks
I have ver 12.1.(13)EW on this switch. We have a Fluke OptiView to help in network troubleshooting. But in order to pull a history from the device I have to turn on RMON.. In the 4006 under config t... You have two choice with RMON alarm or RMON e...
I would like to set up a loopback interface on a remote router I have so I can take the link down and make changes on the remote end...far end address is10.48.1.2 255.255.255.0ofcourse there is a route to it from my core...I tried a loopback address ...
Router(config-if)# rmon collection history {controlEntry integer} [owner ownername] [buckets bucket-number] [interval seconds] Enables an RMON history group of statistics on an interface. rmon collection history is what I believe I have and natural...
RME version 4.0.6I don't understand what you mean my diag images? I know i am pulling from the flash on the device is it something to do with that? I will double check TFTP..
Looks to me that the credentials are not working. You may want to telnet into your devices and double check your snmp credentials etc... and make sure you check device and credentials under common services.
Reason for this is..Seams that when I do a device descover and then a data collection in CM 4.0.12 we have some old routes still in our configs.. And somehow it is reporting that there is a router maybe due to a static route that isn't there anymore?...
