Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a stack of 4 3850 switches Switch# Role Mac Address Priority Version State------------------------------------------------------------1 Standby 00eb.d5e2.7880 15 V05 Ready*2 Active 188b.4583.1480 14 V05 Ready3 Member b090.7ed4.a400 13 V06 Rea...
We have a Shoretel VOIP system and I want to ensure I have QOS properly in place on my 3850 and 2960 stacks. We want dscp 46 to have higher priority from what I understand. We basically did "auto qos voip trust" on all user ports, and "auto qos tru...
We have Shoretel/Mitel VOIP IP phone system. I am wondering how I should be adding QOS to a 3850 switch vs a remote site 2960 switch? What does the configuration look like on 3850 vs 2960? 2nd Question. When implementing QOS through your network, ...
I have followed these instructions:
https://www.cisco.com/c/en/us/support/docs/switches/catalyst-3850-series-switches/117552-technote-cat3850-00.html
When a reboot is done, only one switch stays with the correct updated IOS.
The other switch only c...
We currently have 2960 stacks in our uplink closets at East. We are going to replace them with all 3850 switches next week. What I planned on doing is copying the current 3850 config at East campus MDF to the new switches in IDF and of course chang...
I ended up replacing the switch with the replacement one they sent me. They did however let me keep the old switch that POE was not working on. Now I am interested in the cold reboot to see if POE works on it. Do you think just remove all cables then...
So would I go to one of the current stacked switches and unplug one of the stacking cables to get it offline do the IOS upgrade, then proceed to do the same on each switch? until they are all upgraded to the same IOS as the one I'm adding, then reco...
