Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello:I have a router 2901 with an EHWIC-4ESG module installed. The switch module is working fine, I created several SVI and Intervlan communication is working, however, I can not get any host in my internal VLANs to communicate outside the router, n...
Hello:I have a couple of N5k 5.2(1)N1(1). I'm trying to create a switch profile for all vPC configuration. They are connected to a OOB network through their mgmt0 interface, and ping is succesful. However, the show switch-profile status command shows...
Hello:I have the following network and would like to know whether I need a WLC per site.There are 3 different sites with the followig equipment:Main site: one NAC server (CAS), one NAC manager, several APsBranch 1: one NAC server (CAS), several APs.B...
Hello: I have a question regarding LFI: is FRF.12 fragment size calculated using CIR or interface access rate (clock rate)?.In the Ciscopress book "IP Telephony Self-Study Cisco QOS Exam Certification Guide, Second Edition",pag. 486 ( Link Efficiency...
Hello: I have a Core c6509 (bootflash:cat6000-sup2k9.8-1-3.bin) with a WS-X6148-RJ-45 in slor 5. Recently that module suddenly failed but in the output of the show module command, its status was OK, and no logs were generated, eventhough all leds wer...
Hello Everybody:
Due to burocracy I did not get access to the other end router (the 2800) but I'll keep trying to figure out what is happening. I'll wright if a get any solution.
Thanks a lot for your help! Faimy.
Hello Glen, Richard:
I think am getting access to the 2800 this afternoon, I'll make some tests and copy the configuration.
Regarding the VLANs, yes, they are all created in the VLAN database.
Besides, there is communication from 10.20.0.2 (which i...
