Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My customer Cat65 VSS switches down due to power.The standby Cat65 was failed, I convert it to standby then back to VSS.The standby Cat65 got the following messages then to rommon> "cisco IOS Software, s72033_sp Software (s72033_sp-ADVENTERPRISEK9-M...
My Cat65 can not auto-reboot now. Someone can help me?rommon 8 > dir bootdisk:Initializing ATA monitor library...Directory of bootdisk:8602 76314468 -rw- s72033-adventerprisek9-mz.122-33.SXI5.bin2 33554432 -rw- sea_console.dat2050 ...
My customer has various Cisco switches but only cisco 2950 switches has the problem of ping timeout or reply time is too long(average morethan 2 sec). It will cause I Network Mangement software alarm always. Anyone has this problem?
Anyone has suggestions?I was convert switch2 to standalone the back to VSS mode three times but the problem is still there.Switch1 show switch vir red mis "Startup Config Mismatch:Mismatch in config file between local Switch 1 and peer Switch 2: ACT...
rommon>i keyin resetthe first message is: System Bootstrap, Version 8.5(4)Copyright (c) 1994-2009 by cisco Systems, Inc.Cat6k-Sup720/SP processor with 1048576 Kbytes of main memorySystem Bootstrap, Version 8.5(4)Copyright (c) 1994-2009 by cisco Syst...
I did try this:devsetsyncresetboot bootdisk:imagefile <--------- on this command the cat65 sup720 can boot system, it is entering IOS bootdir boot <---- it is only enter rommon>, I already boot-up sup720sync reset <---- same as above
a) ping ttl range from 400ms up to 3000ms b) no stp problemc) speed/duplex ok.Only the traffic pass through that switch is average about 1700 packets/sec.
