Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Unable to limit traffic on catalyst 3750 gigabit ports it has fiber modules, I want to limit traffic 2mb per portI have tried srr-queue and policier but it is not working and there is no ratelimit command under any interface,Applying policy to output...
I have catalyst 3750 I want to controle traffics on every port I have tried Frame-Relay Traffice shaping and Quality of service but there is no support for these commands in the switch.do we have any way to limit traffic on every port in catalyst 375...
Hello!I have three cisco switchs one 3750g and two others are 2960 series these three switchs are connected throgh trunk ports they have 15 vlans.3750g provides ip (DHCP pools) and I have ubuntu server wich act as a firewale and pr...
when i connect two cisco 2960 series switchs via stright trough cable causes delay in transmission sw1 has vlans and having trunk port connected to router all vlans are able to access internet sw2 is connected to vlan5 on switch1 sw2 has factory defa...
I have cisco 3825 router with two interface one with public ip 182.50.190.140 and the other with private ip 192.168.1.1 and the DNS is 66.28.0.45, I configured NAT overload on it to access internet I can ping public ip nad default gateway but cannot ...
But my download speed is a bove why it does't controle it, I have specified the policy 2mb but my download speed is above 10 mbps it seems that I should apply the policy to output of the interface which is not supported by by catalyst 3750 what sh...
yea I have enabled mls qos globally FiberSwitch#sh mls qosQoS is enabledQoS ip packet dscp rewrite is enabledFiberSwitch#sh mls qos interface gi1/0/4GigabitEthernet1/0/4Attached policy-map for Ingress: rate-limittrust state: not trustedtrust mode: no...
unable to limit traffic on catalyst 3750 gigabit ports it has fiber modules.I have tried srr-queue and policier but it is not working.policy-map rate-limitclass class-defaultpolice 1000000 8000 exceed-action dropint gi1/0/3service-policy input rate-l...
