Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I am running Prime infrastructure 2.1.2 and added my routers to the inventory. We are also in the process of replacing them from 1811 to 2911 and keeps the same configuration from an IP perspective plus our minus a few other command lines. PI...
I am starting out with Cisco Prime infrastructure and I created some sub groups under the Wan Links which I would like to modify the criterias our delete and I can't find the proper way to do so. Can anyone help out here ? Thanks
We've been deploying some AP 2700 within our offices and been observing some "unknown protocol drops" on the switchports where the AP's are connected. The AP's are associated to a 7500 wireless controller, running 8.0.100.0 code. The AP's are in lig...
I am in the process of deploying a whole bunch of Cisco AP to replace existing wireless infrastructure. I have configured FlesConnect groups as all the AP's will share a same config. Because there will be many AP's, I would like to preprovision the...
We have MAB configured on our switch ports and I have a case that I would like to force reauthentication through SNMP. Would someone know the MIB object to trigger the reauthentication of a particular port and the value to write so that it gets trig...
This is not really what I was looking for..... mainly, the issue here is a filter issue..... The device is properly discovered after the replacement, but in the display, it still shows up in the pre-change router model.....
Sorry I should of clarified.... Yes under the user defined groups, If I hover I can modify and delete. But I also created port grouping under the WAN interface builtin group which I don't seem to be able to do anything after the sub group is creat...
Rasika,Thanks for the answer, but the jumbo frame issue seems to be specific to a version of code, which I am not running..... I'm running 8.0.100.0 code so not sure if I am affected by the bug for jumbo frame .
