Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have read that N9K doesn’t support RSPAN but I see at my boxes that the vlan 666 is a remote span.
What is more interesting that is working fine however I don’t know how vlan 666 was defined.
I ask because nowadays I couldn't create next remo...
Hi,
I try to add a new member to existing stack and I can’t because on the a new member at the console I can see log
STACKMGR-1-RELOAD: Reloading due to reason active removed before switch became ready.
What does “Reloading due to reason active r...
First of all I have four stack and I noticed the same problem with all of them when I’m adding a new member to stack. The scenario of action is as below.
1. There is stack with for example 5 members.2. Adding a new member with the same software versi...
Hello, I noticed a problem with connecting host to c3550-24 or c3550-48 through 10/half duplex. When In the network there is cisco catalyst c4948E. Let’s say that there is a network like on the diagram number 1.Diagram1. C4948E -------1G---c3550-1...
Obecnie ModerowaneI would like to ask about a real cause of disconnect voice connection based on the result which is bellow. Log from Cisco router.ISDN Se3/0:15: RX <- SETUP pd = 8 callref = 0x1A52 Sending Complete Bearer Capability i =...
Hi
I know it is strange but in my case I don’t want to use nexus 9K as source or destination monitor session. I want to use them as transit network for RSPAN VLAN in my case it is the VLAN 666.
Diagram1.
Catalyst 3650 (sw1)======VPC=====N9K[1-2] ==...
