Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I worked on ASAs previoulsy, many version ago. This new 8.4 IOS is kind of throwing me for a loop. Also I have been out of firewalling for some time and trying to get back into the swing of things. So anyway, basically I am just trying to p...
Hi All,I have set up a ssl vpn test account and installed a cert on my asa 5510. when i go to the webpage i get the logon screen and then immeadiately after i log in i get a screen saying certificate validation failure. when I click the cert, it is ...
Hi All,We currently have several 3750 switches spread between floors with dual fiber uplinks between each floor and the server room. I have been asked this question. Is it possible to get a stackwise cable that runs the entire length of floors to c...
Hi All,I have a catalyst 4507r with supervisor blades WS-X4515. Can someone tell me the model of the trasceiver that fits into these blades for fiber connections?
Hi all,I posted another question about not being able to get my 1200 working with clients but I think I need to take a step back and take a closer look at my initial setup. I have this AP on a switchport but after thinking about this, I have vlans I ...
I see now I should be using a static nat but the usage is still a little confusing to me.when I enter the above and then do a packet trace on it I see the following:static translate /4576 to /4576which doesnt seem to make sense as to what i am after....
so more info...I setup a guest SSID on a different vlan and I can successfully connect to the unit. can someone please let me know if my config looks ok for the PEAP part?Again..I have looked at the IAS server logs and nothing...also nothing on the ...
Thanks for your reply. I have followed these guides and believe I have a working initial setup. The radio interface is up up and I have configured it to work with my windows IAS but I am still unable to connect from my clients. does my config look...