Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Traffic not going through the DMVPN tunnel
Some of our spoke traffic is not going through the tunnel to either hub. Our connection from the hub to spoke is over a point-to-point radios. We have an outside eigrp 100 network and an inside eigrp 60 netw...
I need to set up secondary SolarWinds NPM Server. I looked at the document for this command and is all I need to do is to add 2 SNMP management workstations is type the command snmp-server host (IP of secondary server) version 3 priv npm-account.
...
I have a router thats one interface (GigabitEthernet0/3/0) flaps a lot. A The model of router is Cisco 2811 (revision 53.51). When I do the sh int command the output looks fine. #sh int GigabitEthernet0/2/0GigabitEthernet0/2/0 is up, line protocol ...
I have a WS-C3750G-24PS that port (GigabitEthernet1/0/26 ) keeps disconnecting. The last time it happened I did a shut/no shut and it went back up. My opinion is that it is SPF. What debug commands or commands period can I use to isolate if this is ...
I work for a organization that states that VLAN 1 must not be used on any switch in the organization. I also have another requirement to ensure like devices(server and workstations) are in there own VLAN. So I did a shut on VLAN 1. Then I create a ne...
How can I confirm that the switch is indeed booting off the config in slot0: and not the one I temporaily stuff in nvram:?When I do a sh bootvar it is blank?
I noticed the boot system flash : command pointed to some wrong places so I kicked out the config lines that were incorrect.Then copied the running-config to the nvram:start-up config. and the config on the slot0:switchconfig and did a reload. Boote...
