Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2610 router. How can I tell if the built-in ethernet port is only a 10BASE-T or if it's a 10/100 port? Is there a "Show" command to give me this information or did it only come one way? I have found conflicting information on this :-( If ...
I have a 2610 router. How can I tell if the built-in ethernet port is only a 10BASE-T or if it's a 10/100 port? If it's only 10BASE-T, can I upgrade it to 10/100?Thanks,Gregg206-795-0597
I'm getting complaints from customers that my router slows down, then doesn't respond for awhile -- then it comes back on. I've checked and it has not power cycled. I've also noticed that trying to login that sometimes it's hung and cannot access i...
I cannot login remotely with HyperTerminal or an internet browser to my Catalyst 2912 Series XL switch. Any ideas? I can get to the login screen in HyperTerminal .. but it will not accept my password. I I tried HTTP using my web browser and I ca...
Very strange ... I cannot login remotely with HyperTerminal to my Catalyst 2900 Series XL switch. Any ideas? I tried HTTP and it won't even bring up the login screen. Is there a remote way to reboot the router?Thanks,Gregg
Hey Joe ... until I can replace my router, I'd like to use my CiscoWS-C3550-24-PWR switch to do routing. My upstream ISP provided me with a/23 IP block and they are using VLAN 758 tagging. They installed their ownCisco switch in my NOC -- so I'd li...
Just to clarify ... I'd like to use port 24 as the WAN port using VLAN 758 tagging and use the other ports as LAN ports using the /23 IP block, as well as using private IPs. I'd like to do subnetting on both the private and public IPs.Thanks,Gregg
