Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys.I have an environment with a single CM and multiple appliances.The Central Manager has two management interfaces (one interface in the primary CPE and another in the secondary CPE). This is in this way because we are unable to use the local s...
Hi guys.Today I was analyzing an environment which runs OSPF. The router has some external routes. I got, as example, the prefixes 10.1.1.0/24 and 10.1.1.0/25 from one router and 10.1.1.0/25 from another.Everything is working fine but when I issue "s...
Hi guys.Today I got a request to insert an equipment to our monitoring system.The customer already has its monitoring system with its configuration.Since I only manage the WAN, I would like to make polling and also get traps for only a specific BGP p...
Hi guys.I am about to support a new customer which has two sites. There is a cisco router in one site and a juniper in the other site.I am used to monitor Delay, jitter and packet loss when using Cisco equipments.I am not used to juniper... is that p...
Hi guysToday I got a customer that installed a WAE device on its LAN environment.Basically, they engineering team, for some reason, did not allow to be directly connected to our router so we have the WAE device on a different vlan from the router sub...
Hi.You understood correctly and the suggestions were good.We decided to move the cables and connect them to the LAN switch. Then, we have created a dedicated vlan for management purposes and we put the two CPEs, the appliance and CM within the same s...
Hi Alain.I see what you mean. Since there are two network IPs (even with different subnet mask) for the same advertising router, it must differentiate one from another. Normally, the link state ID is the network IP (all bits 0 in host portion), but w...
Hi Amrinder.Thanks for replying. With Cisco equipments, I am used to configure one side as monitor and another as responder. My concern is related to Cisco being the monitor and juniper as a responder, how can I configure it as a responder (if that´...
For now, the only thing I could do is to keep the global configuration on it and just add the "no snmp trap link-status" under the signaling interface.In this case, it suppressed all the B channels traps.This is not the best way, but works.I am stil...
