Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am having trouble finding clear information on how to configure two 1572 APs as a wireless bridge.
Currently I have 1 2504 Controller on version 8.0.152.0
I am using a meraki switch to power and connect the APs into the network, in the ...
I am adding new APs but when they boot up they use the address of one of the Switches making it impossible to SSH into the switch.Isn't the AP suppose to make sure that the IP address is available?How can I force the AP to change its IP address witho...
Do I have to set a static channel? currently I have it configured as channel DFS.That is the template I was using for the configuration but I see the issue arise when I configure the WPA2. Here are the configurations I use for the WPA2:int dot 1encry...
AIR-AP1572EAC-B-K9I have 1 5 GHZ only antenna on each AP connected on plug C & D. I did not connect a 2.4 GHz.I have an ac plug into the AP and no power issue.I know in the WLC I can configure it as a songle mode antenna. How can I do that with auton...
I tried it without the any security. No issues.When I put WPA2 the reassociating come back. it keeps deauthenticating and reauthenticating.This isthe logs i keep seeing:*Mar 1 04:20:05.859: %DOT11-6-DISASSOC: Interface Dot11Radio1, Deauthenticating ...
It seems it keeps establishing connection. Will it have an issue with connectivity? Does it dissacosiate when it associates with the EAP-FAST? just trying to understand if this is normal.
I keep getting this message:
*Mar 1 04:29:29.439: %DOT11-4-UPL...
This looks good. Thanks.Another question. I was able to get the APs loaded with the Autnomous IOS.But on the switch sides I have the interfaces configured with an IP address as such:Switch A interface GigabitEthernet1/1/1no switchportip address 10.0....
