Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been testing agent workflows in my home lab and wanted to compare notes with people here. The setup: a factory-blank Cisco Catalyst 8500L. By hand, I gave it only a management address, a hostname, a crypto key and SSH. Everything else came from ...
@pcevans The Edge is doing what it was told. The Validator address in that check is 192.168.12.171 (looks like the VPN512/mgmt side), while your system vbond is 192.168.255.171 on the transport side. Gi1/Gi2 have no real path into 192.168.12.0/24, so...
@daniel-agyei the FN63942 pointer from @Mark Elsen is the right first stop with a 2702 on 8.5. If the MIC or SSC cert on the AP has expired, the join will fail even when CAPWAP discovery looks fine.Run these on the WLCconfig ap cert-expiry-ignore mic...
Hi @HQ_Establishment, You're not imagining it. What you're running into lines up with a long-standing Meraki behavior that got a lot more visible (and more annoying) around MX 26. Layer 7 Geo-IP does a good job on destination country for outbound tra...
@talasgair I think @aleabrahao is on the right track. That capability flag is about whether the AP platform supports the power policy feature on the code you are running. It doesn't reflect what PoE level the AP happens to be sitting at right now. Ci...
Hi @Sam Caprio, "dreopt" is the DRE (Data Redundancy Elimination) optimization service that's part of AppQoE. That error usually means the configuration group is trying to push a DRE/AppQoE setting that the device can't validate, so the push fails be...
