Hi,I use call pickup groups with notification (CUCM 8.6.2). Notification (Call Pickup Group Notification Policy) is set as Visual Alert. All works fine, but the only one problem is, that the notification which is displayed on phones is set on 10 seco...
Hi,I use “connection trunk 26“ syntax on voice port and number 26 match with VoIP dial-peer. VoIP dial-peer uses UDP SIP as transport protocol.All works fine, but my problem is that if destination device goes down, call (trunk) is still active and RT...
Hi,I upgraded form UCCX 4.2 to UCCX 8.5In UCCX 4.2 I had trigger with number 32XX and all works OK. But When I create this trigger in UCCX 8.5, call is rejected and in log I see this error:14739: Aug 25 17:00:58.086 CEST %MIVR-SS_TEL-7-UNK:CallID: 9,...
Call pickup group notification timer sets delay between the time that the call comes into the phone and the time that the notification is sent to other phones in pickup group.
Hi Paolo,Thank you for your response, but I’m looking for automatic “connection tracker”. I need some SIP/ICMP keepalive and disconnect all calls in situation, when a destination device doesn’t response.
Hi Mark,Your configuration is for H323. I tried this configuration with progress indicators for SIP (session protocol sipv2) and behavior is same – GW receives alerting from ISDN PRI and sends 183 Progress message instead 180 Ringing messagedebug isd...
Hi,I read this document, but it looks, that with sip-profile it’s possible modify only message content, but I need modify message code (message type).On which depends 180 and 183 messages? When GW sends 180 and when 183 message? I don’t understand, w...
