Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey everyone,I'm setting up an ASA HA pair with active/standby mode. I had entered the commands below, and the last step was to enable failover on the primay with the 'failover' command.When I entered this, I lost connectivity to the Primary firewall...
Good morning,I have some questions regarding the topology options for the Nexus 5000.In the documentation it states that the 5000 will support up to 12 FEX (fabric extenders).If a vPC topology is used, where each FEX is connected to two 5000, how man...
Hi All,I'm trying to do NAT on one end of an IPSEC tunnel, which I believe is now possible (http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t13/ftipsnat.htm).Setup as follows---NetA---rtr-A-----rtr-B-----NetBThe objec...
Hi,I'm testing a modem to attach to a pix for a remote site install. The thing is that the modem works fine with a router (using the modem in out command under the aux port) but when connected to the pix I get no answer. Is there any config that ne...
Hi,We currently have a setup where an office has two VPN connections with two differentISPs and two PIXes. Even though the office is in the same building, essentially it currently is two separate networks, with each PIX providing a VPN connection fo...
Jennifer,I made the changes to get this working today, some points of interest1) When the 'failover' command is issues on a the primary device (configured with 'failover lan unit primary'), if the other device is 'active' then it is the 'active' devi...
Hi Jennifer,The devices are currently in a different geography to me, them being in HK and myself in Sydney - i've asked the local support to connect console access via VNC so I can see what is going on as you suggest.Regarding the secondary firew...
Hi Jennifer,The secondary firewall had no config apart from what is listed above. That is, it didn't have any IP addresses configured save for the failover interface. Because it hadn't ever formed a HA pair with the Primary, the Secondary unit neve...
