Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Show IP ospf events
ABCD# show ip ospf event
OSPF Router with ID (1.1.1.2) (Process ID 100)
1 May 20 21:35:31.495: Bad pkt rcvd: 172.19.122.8942 May 20 21:35:31.475: Bad pkt rcvd: 172.19.122.9043 May 20 21:35:31.351: Bad pkt rcvd: 172.19.122.9054 Ma...
HI Friends,CISCO 871 router lose it's startup config after few months & we've to connect it through console in order to configure it again. During console access we've found config-register is showing 0x2102 so we can't tell that the router bypass th...
HI friends,I'm having a major problem at my office. We've cisco 1841 router at one of our branch. From last few weeks we have to configure the DHCP pool & rest of the DHCP config once the router reboots at morning. The reboot is not accidental as som...
As we all know #clear counters interface - command will clear interface stats. Now if the counter automatically clears & interface stats reset after few seconds then how can we solve the problem.As per my scenario - Everytime I run #show interface f...
We have this issue couple of times. 1 solution for this is to - make the ospf interface point to point with - ip ospf network point-to-point or ip ospf network broadcast.
On u r router u need to increase weight or local-pref as people are suggesting to u.
Also u need to take care that u don't become a transit path once any ISP fails. For that u can configure - as-path access-list.
Following example will block as 123...
writing x86 kernel core file - System halt.Don't worry try few of these steps - Restart u r physical system. Go to BIOS & search for the option - virtualization technology or VT. Enable that. Make sure U R bios battery is not expired.On VM (virtual b...
On access switch 2 - The port (g0) connect to AP (192.168.50.11) must have access port enable instead of trunk & switchport access vlan 50.Because the AP is a transparent bridge & act like a host so the vlan 50 tagging must be done on g0 for communic...
