Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,
I need to activate netflow on Cisco 3750.
when i checked show flowcontrol i see the flowcontrol is unsupported. Please let me know how to activate the same.
eash
L3SW#sh flowcontrolPort Send FlowControl Receive FlowControl RxP...
I am facing slow data transfer in my LAN. In the LAN I have one Cisco 3750 L3 switch connected to two Cisco 2960 L2 switch in the same rack. There is no VLAN configured. The transfer is very slow i get about 1 MB/sec to 2 MB/sec for any data transfer...
Dear All,
I have one customer there are experiencing high latency from their LAN. When I tried extended ping from the router the latency was 124ms to 144ms. When the customer is pinging from the LAN the latency is 260ms. We the customer disconnec...
Dear All,
I have one customer there are experiencing high latency from their LAN. When I tried extended ping from the router the latency was 124ms to 144ms. When the customer is pinging from the LAN the latency is 260ms. We the customer disconnected...
Dear All,We two offices connected by 100 Mbps ethernet link. recently we added one more 100 Mbps ethernet link for load sharing and reducancy. I planned to configure ip cef on the both the routers, ip load-sharing per-packet on interface with proper ...
Dear All, Please find the capture of sh line and sh line 1 we can see that the modem inout is clearly shown. But in sh line 1 we can see that the modem hardware state is showing CSR* DSR* DTR RTS. I am not getting router login prompt. I can see the m...
Hi My AP is AIR-CAP1702I-D-K9 connecting to SG350 sw. On the WLC 2504 I am seeing DC full power instead of POE full power. Please let me know the about the visual bug. I am running 8.5.130 IOS on the WLC. Regards,Eash
Hi Georg,
Thanks for your suggestion. We are requesting a customer for downtime for re configuring the swiches.
In meantime when I go through the wireshark capture of about 10000 packets, I found 60% of the packet are arp request for an non exist...
I configured storm-control to avoid broadcast, Multicast and unicast on all ports of the 3750 L3 switch. The file transfer speed dropped to 750kb/sec. After disabling the storm-control command the file reached to about 2mb/sec. I checked the packet c...
Hi Flavio,
I checked the error count was not increasing.
The port showing half duplex that system is not used much.
I have attached the config of the L3 and the two L2 switch.
The file transfer is very very slow. I have configured backup ex...
