Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we have pix 525 with version 6.3(3), we have server installed in dmz network with www & ftp service running on it. just recently, we experience problem accessing the server using http from both inside and outside it take a lot of time to display a lo...
We have ciscoworks2000 LMS 1.0, we have two local routers one is connected to remote sites using leased line HDLC and the other is connected to remote sites using frame relay. there is no problem with routers using HDLC it appearing on the topology m...
I'm having trouble trying to configure cisco 2612 router to connect SNA server to datacenter host. please refer to connectivity below.SNA server--eth----router--t/r--control unit--modem-SDLC---modem---FEP the controller unit has token ring card insta...
We have Two sites connected with both fiber and aironet 350 wireless bridge. We installed the wireless bridge to provide backup link when other link goes down, but when we activated the two link in the same time the connection become unstable.we got ...
We have 2621XM router with 32MB DRAM installed on it and we want to upgrade it to 40MB. is it possible to add one more DRAM or upgrade memory from 32MB-40MBThanks.
Hi Matthias,from the attached show lnm station and show source-bridge. 4000.1305.2100 is the dmac configured on SNA server when it is connected thru token ring and it has t/r mac 4000.1305.2102. when connected thru ethernet, I did bitswapped the dmac...
Hi Matthias,working topology:SNA server with 2 NIC ethenet and T/R--eth-SNA-t/r---control unit-modem--sdlc--modem--FEPwith router:not workingSNA-eth-router-t/r-control unit-modem-sdlc-modem-FEPplease checked the router config below, thanksCurrent con...
Hi Nadeem,Thanks for your reply, please check the attached file "show conn"..we are accessing 10.149.72.50 for ftp ok but http takes a lot of time to display login page..10.149.72.53 is our proxy server..Thanks,Ador
I'm configuring 2621 router with one fastethernet module installed on it to have a total of 3 ethernet interfaces. inside LAN is connected to fa0/0 and two internet connection dsl1 & dsl2 is connected to fa0/1 & fa1/0 respectively. we have web server...
