Good day everyone, I would like to as some assistance from you guys. This is with regards to our router, after unboxing it and did some basic router configuration then saving it, after some reload it gives out an error like: Possible software fault. ...

Good morning, I have a Cisco SG300-10 10Port Gigabit Managed Switch that is set to L3 Mode. I have set 2 vlan (vlan 30 and vlan 40) and set a static route from our firewall so the vlan can connect to the internet. Now as I go further, I would like to...

Good day everyone, I am hoping that someone would be able to assist us in the configuration of our router. We just purchased this router, we did the initial configuration with the help of some documents. And now, when we try to configure NAT for us t...