Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,Wondering what people use to ensure they are not calling numbers that are on the National Do Not Call List. For example, Employee Joe calls an outside number, the number would be checked against the National Do Not Call list. If it is on t...
Hello all,I want to add a 9 to all inbound calls to Call Manager so the user can just hit redial to return the call. I’ve created the following in the router and it works as design:Sample is for the Atlanta calling area:voice translation-rule 2rule ...
All of my extensions begin with 842 and are 7 digits. When in normal operating mode I have a translation pattern in CM that allows internal dialing of just the last 4 digits. When I'm SRST mode I want to allow the same 4 digit dialing between phon...
Hello all, looking for some help.
When I'm in SRST Mode (all SIP Phones) it takes 12 seconds for the phone I want to transfer to to start ringing. I press Transfer I get dial tone right away, I dial my extension then I have to wait 12 seconds before...
Hello All,
I have 3 dial-peers all set with the preference command. Even though dial-peer voice 8 is the highest number (Preference 9) it's always selected over the other two. My goal of dial-peer 8 was to be used only during SRST mode, which it do...
Giuseppe,Thanks for the reply. Yes, currently the 10GE is the only connection between the sites, so all communications will go over this same connection. I see your point about a problem should this link go down. I will have to address that as we...
