Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I am looking for a little expert advise regarding Cisco Netflow. For monitoring I need to enable Netflow feature on 6500 core switch or 6500 load balancer with CSM module installed, but I am just concern about the CPU hits on the devices. we a...
Hello All,I would appreciate if someone can guide me to resolve the following issue. I am setting up anyconnet vpn server on the ASA firewall for one of my client. VPN client is a virtual server at remote site. Server can dial in and access resources...
Hello All,I working on a security solution using ASA firewall and need some technical advice on ASA. Is it possible to setup a IPSec tunnels on each subinterface of a physical interface on ASA 5510? I would be greatul if someone please reply post th...
Hi All,I am planning to upgrade the IOS on my cisco 3750 switches and need some help to identify the correct version of software. At the moment I am using 12.2(35)SE5 and 12.2(50)SE1 on majority of the switches but 12.2 and 12.1 as well on some switc...
Hi All,I would appreciate if someone can comments, if they have any experience or came across with any issues regarding NATing or ACL setup for NAT ranges after upgrading ASA from version 7.2 to 8.3 or later?At the moment we are planning to upgrade e...
Hi Jennifer,Thanks very much for your reply. I understand where you coming from, but the reason of using sub-interfaces is that, we have only one physical interface on the firewall connected to the MPLS cloud, and we need to setup a seperate IPSec t...
Hi Jouni,Thanks for the reply. The basic idea behind NATing is to hide the 10.210.x.x subnet connected to the outside interface of the firewall from the inside. In the current scenario we have 10.210.x.x subnets in the production and same subnets in...
