Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working on an EEM script, but I've come to a roadblock. My script needs to run multiple commands, and it can run them all except one. This is a command that needs quotes in the command itself.
Is there a way to get an EEM script to run a command...
I was able to fix this without having TAC do some intensive backdoor actions.
Go to FTD command line
system support diagnostic-cli
enable (if needed)
show run
look for the dns policy map. Mine was similar to:
policy-map type inspect dns preset_dns_m...
I had an issue with configuring my router with built-in mobility express AP. Here was my specific situation: C1111-4PWBCisco IOS XE Software, Version 16.09.05Cisco IOS Software [Fuji], ISR Software (ARMV8EB_LINUX_IOSD-UNIVERSALK9_IAS-M), Version 16.9...
With Prime Infrastructure, is it possible to make a template that allows you to choose the switch, then the interface, and then apply a template? So far the best I've come up with is to deploy a template where I have to select a switch first, then in...
I had this issue with a 6880, and it was a really dumb mistake. boot-start-markerboot system bootdisk:c6880x-adventerprisek9-mz.SPA.151-2.SY2.binboot-end-marker!CORE-6880-VSS#issu loadversion bootdisk:c6880x-adventerprisek9-mz.SPA.151-2.SY3.bin% CV [...