Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the SPA232D with SPA302D dect phone .
basically I want the PSTN line ( Main line ) to ring on the Dect Phone as well as be able to forward PSTN to VOIP as soon want to transfer the line PSTN to another locations VOIP number with caller ID tran...
Well basically my situation is as follows: we are using 40 Cisco AIR-AP1242 around 3 building sites for our school ( Ramsey Grammar ) which all are secure WEP and working fine however we would like to have two locations open and Virtual LAN direct to...
I've done a bit of reading about PoE for the 2626-PWR however I'd like a confirmation on a few bits...1. Does the ProCurve 2626-PWR Supply Power for PoE to the Cisco Devices or would I have to use the Cisco PoE Injector module one for each Cisco AP1...
Did you get it working ?
My issue is that a incoming PSTN call doesn't even make the SPA232D + SPA302D flinch like its not plugged in , dect is gone can't even dial out on it just the SIP accounts work on it
Locations are :1 x Cisco Air-AP1242 in the 6thForm Lounge & 1 x Cisco Air-ap1242 in the Lecture Theatre All I require is a VLAN setup to Allow internet access only Direct through Proxy without people able to see or ping etc the normal network servers...
HP Procurve 600 RPS/EPS which supplies extra power to PoE and redundant power to SwitchThanks I'll look into the watt of each port a HP 2626-PWR does 24ports @ average of 15.4W each and total Voltage of 406
