About network_engineer

network_engineer · 06-09-2009

Hi all,From this following text, "Peers need to negotiate a common ISAKMP policy in order to establish an IPsec peer relationship. So depending on the devices you expect to peer with, you may need multiple ISAKMP policies. Each ISAKMP policy is assig...

network_engineer · 06-08-2009

Hi all,I have been studying this material here:http://www.cisco.com/en/US/tech/tk389/tk621/technologies_configuration_example09186a008009467c.shtmlCan somebody please explain me in simple language what these commands actually do? I appreciate the mat...

network_engineer · 06-08-2009

Hi all,For the moment, I have a very basic question: Does one always need a router while trying to route between multiple VLANs?Obviously, my understanding is also that a VLAN is also equivalent to a subnet in the roughest of terms, i.e. non-subnette...

network_engineer · 02-06-2008

Hi all,I have the following setup:HOST A - SWITCH B - SWITCH C - ROUTER D - SWITCH E - ROUTER FNow, I understand (and it works) that the connections between the switches are in trunk mode.So, with regard to above:1. SWITCH B interface to the HOST A i...

network_engineer · 02-03-2008

Hi all,I have the following configuration.Cisco Router 2811 [Router_A] <-> 2960 Switch [Switch_B] <-> 2960 Switch [Switch_C] <-> Cisco Router 2811 [Router_D] <-> 2960 Switch [Switch_E] <-> Hosts [Host_F].Now, the Switch_B is configured in VTP Server ...

network_engineer · 06-09-2009

Hello!Thanks for that reply. Further question: On one gateway, only one ISAKMP policy is supported right? Or more? What is the relation between the ISAKMP policy, peer and the priority?Sorry, but I am still a bit confused.Thanks again.Kind regards.

network_engineer · 06-08-2009

Thanks a lot Toshi! Extremely helpful of you!Kind regards.

network_engineer · 02-03-2008

Thanks - much appreciated.

network_engineer · 02-03-2008

Hi Kevin,Thanks. Although, my understanding was that the domain (and thus the name) would also be propagated.Brings me to another question: Is it possible to have a switch configured as a server as part of and serving multiple domains? E.g. a switch ...

network_engineer · 01-05-2008

Hi all,Thanks for the response. That is exactly my question, i.e. when I use the classful network, e.g. 192.168.x.0, then it works, however, when I summarise it to 192.0.0.0, then it does not. RIP v2 supporting classless routing, *should it not have ...

Member Since	‎05-15-2007 01:42 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	19

User Statistics

User Activity

IPSEC, Peer-To-Peer, Polcies.

Understanding STP configurations

Inter-VLAN routing

VLAN Connections between Switch and Router.

VTP propagation

Re: IPSEC, Peer-To-Peer, Polcies.

Re: Inter-VLAN routing

Re: VTP propagation

Re: VTP propagation

Re: RIP: Summary networks don't propogate.