Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all!Wondering if anyone knows of a command that will tell the temperature of a linecard in a Cisco 10012 router. If not, I assume I could get it via SNMP. Does anyone know of an OID that would supply that information? Thanks in advance!
Wondering if anyone has ever had a problem clearing vty lines. I've done it a million times, with success. But now I have a few devices that have some "hung" sessions. I try to clear them, the command is accepted, but the connection is still there...
I am trying to force f0/0 on a 7246 router to 100/full. But I don't see the speed command as an option on the interface. I was able to force full duplex but not speed. Is there a reason why? I assume the answer is easy, but I've never seen this b...
Show env only show's the input and output temperature. I am seeing a big difference between the two, so I wondering where the heat is coming from. SO I wanted to see the temp on each card individually.I just tried show power-mod and that did not wo...
It is a 7246vxrCisco Internetwork Operating System Software IOS (tm) 7200 Software (UBR7200-K8P-M), Version 12.2(15)BC2h, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2005 by cisco Systems, Inc.Compiled ...
