Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am doing image upgrade on Catalyst 6509-E. During TFTP image transfer to sup-bootflash I always see !!!!!!!!!!!!!!!!!o!!!!!!!!!! "o" out of sequence packet. Although the image size seems to be correct at the end but there is always some "o" pac...
Hi,I am upgrading IOS on 6509-E from 122-33.SXI4a to 12.2(33)SXJ3. I have FWSM module on 3.2(10).1. Should I expect any issues with the FWSM while upgrading to the new IOS? 2. Do I need to upgrade the FWSM prior to this IOS upgrade?3. What is the upg...
Hi,I have catalyst 6500s with two VS-S720-10Gs, one is in Active and one is in Hot state. Both Sup cards have two 10G uplink ports. How does the traffic forwarding works in this case on the uplink ports? Do these uplink ports actively forward traffic...
Hi there,I am curious to find out if there is any option to record flow timestamp in Netflow. I have enabled it on Catalyst 6500 switch using version 5. The output of "sh ip cache flow" does not display session timestamp - start and finish time. Is t...
I have S chassis. Cisco document says S chasiis that I am using only supports IP Base and E chassis supports IP Services. How can I run BGP on my S chassis. 3750E does not mean E chassis, it is the letter at the end.
Can I install IP Services image on 3750E-48TD-S or do i need an E chassis? What is universal image? What are different types of images available? I couldn't find all info at one place. Thanks,Fawad
How about doing it from flash. can I load the pkg file on flash and isntall from there? I could not find a link to explain the steps. Your help will be appreciated!
