Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I'm currently evaluating Cisco Prime Infrastructure and I ran in some strange issue.When I add one of our wlc's I do see wireless clients and all kinds of info from the wlc but it can't see the actual access points.(See the attached screendum...
Hi All,Since a couple days I'm experiencing an issue with a C819-4G router.The 4G connection unexpectedly disconnected, and I am unable to get it connected again.There have been no configuration changes, and this config works fine in a spare router.I...
Hi all,I'm configuring a l2l tunnel.While configuring the crypo acl I noticed that my ASA was accepting subnetmasks like 255.255.255.1 (wich does not exist to my knowledge).I then tried some other masks, and to my surprise it accepted almost everytin...
Hi all,Over the last couple days I've been experimenting with the new NAT config with version 8.4(2), and I've got a couple questions.For example:My production ASA is running on version 8.2(3) and has the following config:global (outside) 1 interface...
Hi all,Yesterday i ran into a strange problem.I installed a Cisco 881 router behind a 2960 switch.On both devices i configured 100mb full duplexing, so auto neg off.Also i configured an IP on the interface.So the interface now looks like this:Router#...
Sorry pushed the answer button unintended...
1) ncs status (from an admin ssh logon)
Warning : Unknown hardware type : KVMHealth Monitor Server is running. ( [Role] Primary [State] HA not Configured )Database server is runningFtp Server is running...
No, somehow PI doesn't recognise any access point from any controller.On a previous instance of PI I did not have this problem, so I'm beginning to think there has gone something wrong with the installation.
Based on the TCP FIN, it looks like the tcp handshake is not completed, but based on the logging I can't see why.If you do a telnet outlook.office365.com 993 from te client, do you get a connection then?Also what kind of error message are you getting...
%ASA-6-302013: Built outbound TCP connection 21356473 for outside:132.245.63.226/25 Looks like the connection is made to port 25 instead of 993, looks like an application issue.Make sure the mailclient has port 993 configured, probably a "override de...
