Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 3500xl stack connected by Gigastacks. The first switch and last switch in the stack are connected with the giastack cable as well.The gigastack interface on the last switch in the stack is Green/Green but the gigastack interface on the first...
Does anyone one if there is a best practices for How many VTP servers you should have. Can you leave all your switches as servers, is this advisable? Having only one seems a bit dangerous.Thanks in advance
Has anyone ever seen this: The 3500XL is not reporting all its memory no bin file?Directory of flash:/3 drwx 64 lost+found4 drwx 768 html682496 bytes available (2930176 bytes used)switch:
I've never worked with the 1841's and I was wondering if you can tell me if this solution will work.Our isp is going to hand us two ethernet cables for our WAN connections, one for internet the other for one end of a point to point.Can the I plug to ...
Thats exactally correct but isnt the gigastack config on the 3500xl's supposed to support redundant loop configs??Table 1-5: Minimum IOS Release for Redundant Loop Configurations Supported Switch Minimum IOS Release 3500 XL switches 12.0(5)XU (Ap...
Its cabled with the Gigastack cablesport 2 in the gigastack module is cabled to port1 in the gigastack module on switch 2 g0/1 port 2 in the gigastack module is cabled to port 1 in the gigastack module on switch 3 etc.when you get to the last switch ...
