Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
One of my client received emails from ISP saying the SPAM email generated from their network with PIX outside ip. We want to disable the outbound SMRP (port25) on the firewall, so that the emails will be stopped. PIX config has 'no fixup protocol smt...
Hi all,Simple yet would like to know..If I setup bgp timers as 20 (keepalive) 60 (Holddown)After how many keepalive misses the bgp peer declared to be down..? (one keep alive -20 or 3keep alives -60)..?TIAMS
Hi,Datacenter has T1 to branch office. Branch office got its own high speed internet connection.Planning on letting the Data to pass over Internet (via vpn to datacenter or any other suggested method) and T1 for Voice only and if the Internet goes do...
Hi All,One of our UK office has 2Meg ISP line terminating on Cisco2801 rtr with WIC-1T= installed. The 'Show inter ser 0/12/0' o/p showing it as T1 BW..does that sound correct..?************************Serial0/2/0 is up, line protocol is up Hardware...
The SPAM stopped but unable to find the source IP. I tried port 25 to Internet from known PC, the hit count in ACL increases but PIX logging anythign about the souce (internal PC) in buffer or syslog. I observed few messages in PIX log that the deny ...
question.. I want to enable 'log' with the ACL to see what is the source. It may be hard to tell, but will there be any perf. impact on the PIX as it has to inspect every packet against ACL..?TIAMS
