Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is someone see any mistakes or can comment or suggest on this scenario ?I have a 2801 service router, running CuCME and CUE, which will connect using the two FastEthernet port in etherchannel trunk mode to the C2960 head switch.The same C2960 head sw...
Hi,Any suggestion about how to correctly monitor HTTP Traffic from a certain host ?I just received a request to log, for a specific period of time, http traffic from a host on the inside network to internet and to generate a sort of human readable ou...
I though that it didn't matter to connect a router to the uplink port or regular switch port of a switch.but is there any difference between a regular switch port and an uplink port ? other than speed and crossover...i use to have my router (2801, 10...
Hi,We recently added some workstation, ip phones and servers to our existing network.It seem that we need to upgrade our simple network design.I would really welcome suggestions.Here is what we actually have:1x router 2801 w/ CCME & CUE for 16 users1...
Hi,I hope someone can help me or point me to the right direction, but i am wondering what is the call flow and options that i have to setup analog faxing to a cme/cue setup.I am running a C2801-SPSERVICESK9-M w/12.4(11)XW2 / CME 4.2(0) and CUE 3.1.1w...
Hello Giuseppe,Thanks again for all your help.Correct me if i'm wrong, but the ASA5505 basic license doesn't support trunking. It come with 3 preconfigured vlan, VLAN ID 1 Inside, ID 2 Outside and ID3 (Restricted) DMZ. I do not really understand how ...
Hello Giuseppe, thanks for the reply.If i understand correctly, it is not necessary or pratical to create an etherchannel with both NIC on the 2801, since it is not able to handle the line rate for L3 ?Would you recommended using only one FE in trunk...
We only have a 5Mbps ADSL connexion.I guess the 2801 is fine.I have 6 non-used 100 ports on my ASA5505, which is in between the router (connected to the second Fe port) and the ADSL modem.Right now i am using the ASA only as a bridge for internet com...
Basicly, just to make sure that i am really following,.. I should go with one gig switch with more port or 2 or 3 smaller gig switch to increase redundancy in case of hardware failure, do NIC teaming for my 2 server (if they support it) and keep the ...
