Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,can you please help me to configure dual ADSL line on cisco 2811 router to do WAN load balencing.here i dont have any Static IP form both ISP ,ADSL over PPOA (dynamic)Thanks & regardsPraju
my E1 interface is not coming up ,not reciving any signal from outside .please find my debug and show coommand.anybody can tell me what will be the cause , is it hysical connection probelm or any configuration issue.sho controllers E1 0/2/0Serial0/2/...
Hi,can you please help me to create rules to recive incoming calls from E1 line with DIDs Piolet no is 3642766 (xxxx100 -xxxx199)all incoming calls directly comes to operator phones (hunt group)501and outgoing calls can make from any phone directly T...
I have WLC 2106,And 5 LWAP, 3 Cat3560 Switches.and my 2851 CME router providing DHCP for Data VLAN 1 nad Voice VLAN 100any one can please help me how to do the basic configuration when i configure Managment and AP manager on WLC 2106 on untaged VLAN ...
Hi,how do i configure 2851 CME router with VWIC-IMFT-E1 to recive Calls and another VIC-4FXO for otgoing calls.any one can please help to setup this .please find my sho run configuration here
thanks,i changed the cable and now i can see the status is up but ot able to make any calls or reciving any calls even i lost my secondery dialton RegardsPrajoth
Thanks ,From telco interface is DB 15 and cisco router interface is RJ45And telco Side they came and tested the loop and whyle testing loop they told me when my router is connected to NT box they are not reciving any signal over there but once i rem...
ThanksLike i have created hunt group to recive all Incoming calls from PRI E1 to operator phone . but im not sure about how it will know where to go . normally in FXO i ussed to mention connection plar opx XXX (extention ) number , here how it will w...
Hi dear,do you have any sample configuration the same scenario, like i have planning to go for PRI E1 line to receive calls and FXO for outgoing calls , how to create voice translation-rule for outgoing and incoming how multiple calls can receive on ...
my switch port has configured as trunk witch connected to WLC and it was on native VLAN 1 (untaged) but my WLC Port is VLAN 0 (Untaged) , so i changed VLAN on both side to VLAN 60 and on Cisco Switch i say to allow VLANs 60,1,100.My native VLAN on Ci...
