Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey all. I hope this is a simple one:A 2801 shows this inventory:Installed image archiveCisco 2801 (revision 6.0) with 179200K/17408K bytes of memory.Processor board ID FHK1044F2QH2 FastEthernet interfaces1 ATM interface1 Virtual Private Network (VPN...
It took me some time and many tftp transfers to finally find an IOS that works fine with the HWIC-AP (wireless access point module) for a 2801 router.What I am wondering: Is there an IOS that supports both the HWIC-AP and also includes Call Manager ...
Hello all.I have a HWIC-AP on a 2801 configured like this:interface Dot11Radio0/3/0 ip address 10.1.2.1 255.255.255.0 no ip route-cache cef no ip route-cache ! ssid clust authentication open guest-mode ! speed basic-1.0 basic-2.0 basic-5.5 6.0 ...
Greetings everybody.Is there a sample configuration that I could use to find my routing problem on my 1131? It's running in autonomous mode and I can connect my wireless laptop to the network just fine. A 3550 provides DHCP service. But once I try to...
Scott, thank you very much for responding.Your questions prompted me get SDM to work. I upgraded to the 12.4(15)T IOS, got the wireless application in sdm to work and then realized my mistake! I had to specify "ip nat inside" on my dot11radio interfa...
