Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
We have deployed VSS couple of weeks ago on 4506-E with SUP7L-E Supervisory Engines,
As VSS works fine, we want to go ahead and implement MultiChassis EtherChannel, that’s where we are faced with a bit of a problem on a performance side;
...
I'm having a problem configuring Remote Access VPN (SSL, Anyconnect ect.) on ASA Service Module on 6509-E. Is this even supported or am i wasting my time trying to make something work which will not work in a first place :) ? Site-to-Site works with...
Hi allHaving a problem bringing up 10GB ports between two Cisco 6509-E VS-SUP2T-10GB , they simply are not comming up Physically.Model: 6509-ESUP's: Factory ID: VS-S2T-10GB-XLUsing IOS Image: s2t54-adventerprisek9-mz.SPA.151-2.SY.binTransceiver: X2-1...
Hello Please I need you assistance, I have 2 routers router A and Router B connected with Ethernet to each other, and each router has its own E1 for data traffic. What I want to do is, when E1 on router A is fully loaded I want to send the traffic to...
HelloPlease I need you assistance, I have 2 routersrouter A and Router B connected with Ethernet to each other, and each router has its own E1 for data traffic. What I want to do is, when E1 on router A is fully loaded I want to send the traffic to r...
Yes Marvin i am running in multiple context mode, so I'm done with SSL unless i convert back in Singe mode i guess.Just to confirm will the Remote Access VPN be available if i convert back to a single routed mode ?Thanks
SolvedGlad to inform that the problem was Transiever, all 4 of them !!!, higly unlikely situation but it happened.I have got the same model of Transievers and used them interfaces came up just fine.Will ship those transievers back and get a replaceme...
Hi When connected interface status are as follows:SW-1Router#sh int t5/4TenGigabitEthernet5/4 is down, line protocol is down (notconnect)SW-2Router#sh int t5/4TenGigabitEthernet5/4 is down, line protocol is down (notconnect)Router#sh int status modul...
HiI already have EIGRP running on both routers , yes you can load balance traffic, this i can do, but i want to load balance after the first E1 is full and only them redirect traffic to another.
