Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is the scenario. I have 2 data centers miles apart. They are on a Paetec MPLS. I have a Lightower point to point Ethernet link between the two data centers as well. At data center A, I have a Paetec managed router (192.168.2.1). The subnets be...
So - I am pretty sure I know the answer to this, but I have a Dell install team here telling me this is an issue with my router. I am pretty sure it is not, but I am going to thow it out there anyway -I have 4 subnets. 192.168.2.0, 192.168.100.0, 1...
HelloI have 2 LAN subnets (192.168.2.0 and 10.0.2.0). Both are on the same router. The default route on the router points to our T1. I have redirected all port 80 and 443 traffic out to a different, faster link using a command like this on the LAN...
I have an ASA 5520. I have 4 ge ports. Port 0 is the Outside interface (connected to a T1 with VPN tunnels remote sites), Port 1 is inside, Port 2 is a VPN tunnel to our disaster recovery site and port 3 is open (connected to a FIOS line). What I ...
Hello. I have set up a 1130AG autonomou access point. My users are using Panasonic Toughbook touchpads. Most of my shops are working fine but one will not let users authenticate. I have them using RADIUS to a Windows 2003 server with WPA-TKIP. W...
I am having the same exact issue with 2 ASA 5520s. I can recover the routingby sending a packet from the endpoint using the packet tracer within ASDM. Ididn't notice it until after I updated the ASA code to 8.0 (3). I will be following this for an...
Sorry this took so long - I have just enabled the IAS logs, so I will have to check those. Over the last month I have been tweaking and have it working here and there but it is NEVER consistant. This is the debug now when it fails:Jun 22 17:33:28.0...
Here are the latest configs. Disregard the original one as I have changed some things that have allowed me to keep the working tunnel from dropping. The tunnel that is working fine is the one from Site A:nameif DR-FIOS to Site B:nameif Outside. The...
