Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I’m working on a design at the moment where the customer runs a Zero Trust model, The customer has multiple sites with no WAN. All traffic is Internet based towards there cloud provider where they run SAML aware proxies to permit access to their a...
Hi,
Has anyone configured AWS route-based VPNs that are terminating different VPCs. I.E multiple VPNs.
The AWS VGW service has some restrictions that need to be considered when provisioning VPNs. The first restriction is that a given AWS region c...
Hi,
The Nexus 9300 platform, can these be used in a VPC pair to connect a resilient FEX? As in Active-Active FEX.
Looking at the guide it is...
https://www.cisco.com/c/en/us/support/docs/switches/nexus-2000-series-fabric-extenders/200363-nex...
I can't seem to work this one out... how do you match against an AD group at the authentication level (not authorisation) I have a wide AD group selected under the AD external identity sources (covering all corporate wireless users) I don't want thos...
Hi,I'm current struggling to get PI and ISE to integrate, these are running:ISE 1.3.0.876PI 2.1.0.0.87To integrate ISE with PI, on the PI server I browse toDesign > Management Tools >External Management Servers > ISE ServersI enter all the correct ...
Hi, Thanks for the reply. This is on a 9800 IOSXE controller.. I think this is what im looking for.. "config network ap-discovery nat-ip-only" I can't seem to find that on the new controller. Thanks
Nope, I gave up and just ended up doing a pool. When it did work it would just stop, very flaky feature in my opinion. I was using a context and there where loads of incompatible features.
Hi,
You need a "sh inventory" to get the serial number. The serial number on a "sh ver" will show you the board serial number.
The "sh inventory" command will match (or should) the sticker
Thanks
RG
Is there a way of ordering the alias' At the moment its alphabetical and the profile now being selected by default is the new alias as its starts with an "A" (I know, I could rename it.. but I have config OCD!)
