Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have this occasional problem in one of our remote sites. It seems (based from the "show call active" output below) that when a user hairpinned and call another FXO user on the same router/gateway, the call will stay-up indefinitely. Any ideas? Tel...
I have this problem wherein I'm getting an occassional fast-busy when dialing from GW to another GW. The Disconnect Code I'm getting is "38" from CCAPI debug as shown below. This usually occurs when a I call a different number immediately (about 5 - ...
Hi-I've been trying to work on this issue for a while. I have my VIC2-4FXO port connected to POTS (let's say the number is 200-1111).If I dial 200-1111, I'll hear a second dial tone and can call anyone without problems thru this router.But what I wis...
Hi-I've been trying to find ways to change "2-wire" to "4-wire" on the VWIC2-2MFT-T1/E1 on my 2801. Any ideas? Voice card specific Info Follows: Operation Type is 2-wire E&M Type is 1 Signal Type is immediate Dial Out Type is dtmfI tried going into t...
Hi-How secure is Netflow if the stats are sent over the Internet? I have a Netflow collector in the HQ and wish to monitor the branch router. It supports version 5 only.Thanks.
Thanks Nick, unforunately QOS is a luxury that other countries still don't have. Specially for low-speed, just when you need it most We always use hard, Layer 1 circuit in the past and it's our first time to have MPLS VPN for an inter-country tielin...
Hi Nick-From your thread:"QoS will only really be used when there is contention for the port / tx-ring. "I need to establish a tie-line between our Sydney and San Francisco offices using CME. A 256 Kbps MPLS link fits our budget. But QOS is not avail...
Hi Nick, this is helpful for voice but no significant effect on the ring back. The caller will still hear a 'muffled' ring.Is there any command just for ringback tones?Have seen this command but I think it's only for those not hearing any ringback at...
