Level 1
Level 1
Member since ‎12-19-2003

User Statistics

  • 364 Posts
  • 0 Solutions
  • 283 Helpful votes Given
  • 4 Helpful votes Received
Recent Badges
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

I am running Windows 7, 64-bit, SP1.  I tried to install Cisco AnyConnect client and got this error message.  "There is a problem with this Windows Installer package.  A program run as part of the setup did not finish as expected.  Contact your suppo...
We have ASA 5510, running IOS 8.2(4).  We are setting up two VPN pools for Cisco VPN client.  Do we need to setup each NAT statement for each VPN pool?  How do we setup the NAT statement for the second VPN pool?Below is my current config:ip local poo...
The Cisco VPN client is disconnected after 4 hours of inactivity.  Is there a setting on the ASA that would timeout after 4 hours?  I want to disable this setting.  I am running IOS 8.2(4).Thanks.Diane 
We have ASA 5510 and the Radius server.  We were able to login to Cisco VPN client last week.  For some reason, we got this error message in Cisco VPN client log:  "User does not provide any authentication data".  The authentication never went throug...
We have a VPN 3005 Concentrator.  The user was able to login to Cisco VPN client successfully.  However, she is not able to access the internal network.  The tunnel was setup as a split-tunnel.  Do you have any suggestions?Thanks.Diane
Community Statistics
Member Since ‎12-19-2003 01:30 PM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 364
Total Helpful Votes Received 4
Helpful Votes From