Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Support Community,
I'm trying to connect a Core Switch 3850-12XS (running 03.07.03E) with an Access Switch 2960-X (running 15.2(2)E3) using a Twinax Cable CDE2-SFP-1WCX=. Unfortunately the Cable seems to be not Compliant with the 2060-X Uplink P...
Hello, I just upgrade a WLC2504 with 3 AP (AIR-LAP1042N-E-K9) to 7.6.130 Release. Everything worked fine.Now I'm trying to add a new AP (AIR-CAP1702I-E-K9) to my WLC. Access-Point and WLC Mgmt IP are in the same VLAN/subnet. I also configured Option ...
Dear Support,I have to configure a Wireless Trunk Link between two buildings. I'm using Outdoors AP 1532 with directional Antennas on 5GHz. I want my Wireless Trunk to word exactly like a Wired Trunk between two switches.In each Building I have a 296...
Hi Leo,Thank you for the information, I upgraded to 8.0.120 and I worked perfectly. I already installed AP 2700 with 6.7.130 and didn't read the Compatibility Matrix correctly.Sorry for the wasted time.Kind Regards,Nicolas.
Hi Rasika, It's OK everything works fine now. It was a Native VLAN configuration mismatch.I have all my VLANs carried over the Wireless Trunk.Thank you for helping,Kind Regards,Nicolas.
Hi Rasika,Here is my actual configuration:dot11 vlan-name Data vlan 10dot11 vlan-name Voice vlan 777dot11 ant-band-mode single!dot11 ssid <my-SSID> vlan 10 authentication open authentication key-management wpa version 2 guest-mode infrastru...
Hi Rasika,Thanks for responding. So the first thing I have to change is to configure my VLAN 10 as native as it is used for management of the devices.After that can I add as much VLANs as desired? The only thing I have to configure is a new VLAN with...
