Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiWe are migrating from Checkpoint to PIX. We have inside, outside, and DMZ interfaces. On the DMZ, we will have web servers with private addresses, the outside world connects to these servers through statics on the PIX.We currently have the CP in pl...
HiWe have purchased 8 channels from our telco in the UK. These are channels 1-8 on the PRI circuits. When making an outbound call, the call tries to sieze channel 31 which isnt available.Is there a command that I can put on my h323 gateway so takes c...
HiI have two LD416's to install in a failover bundle, but I am unsure what will happen if a server fails. I need to load balance http traffic. Is there any way that the LD416's can send keepalives to the servers to make sure they are still available ...
HII have the config - see belowI am using ip helper to relay dhcp req's from a server to clients on another LAN. On the LAN with the clients, I need to apply an inbound ACL to limit their access to the wide area network. When I apply the ACL below, i...
HiI want to have a 3600 router terminating VPN connections at the CO from 1700 routers at the spoke sites. I will be using IPSEC/3DES and GRE to allow for routing. But I want to put and ISDN card in the 1700 routers, and provide backup to the CO. I h...
Hi Scott, this does help, but now we have to create a lot more statics and I can't help thinking this may overly complicate things. We have quite a few web servers and quite a few statics from outside to DMZ, and now we would need to create more from...
