Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone I am trying to set up backup connection for leases line using ISDN. I am not running any routing protocol. I have set up only static routes so i want to know what ISDN backup method should i use as i am not running any routing protocol. P...
I am setting up ISDN PRI connection with BRI connection. Need help with the configuration that needs to be done on the TELCO side. As we have the PRI connection with the TELCO and they want us to tell them the configuration that is required to set up...
I need help with ISDN Configuration. Any help will be appreciated as i am stuck here for a long long time. I am trying to connect an ISDN E1 PRI channel to BRI channel on different locations. I am pasting the running configuration of both the router...
I am recieving this error when i am trying to test call my own number This is the error message that i am getting when using debug ISDN q931debug isdn q931 is ON.DSCBL#isdn test call interface s1/0:15 23252112DSCBL#*Nov 5 09:33:26.286: ...
I want to connect a PRI ISDN line to multiple BRI ISDN lines as a backup route. The PRI line is present at the server, all the clients have a BRI line. I want to connect them together as a backup route to the server using Legacy DDR routing on ISDN. ...
Thanks for the quick reply Giuseppe. Really appreciate it. I tried with what you have said and other different methods too. The issue is when the connection from Deoli goes down it dials to the DSCBL router but the DSCBL router is still using the mul...
I got all this information from the TELCO. Please suggest the correct configuration to run PRI 1. Is the PBX designed for Pre-National or NI-2 protocol? -Protocol using C7MATL2. Are there any DID station numbers that your CPE cannot a...
Here is the ISDN status of the PRI interface at the main office DSCBL ISDN STATUS :Global ISDN Switchtype = primary-net5ISDN Serial1/0:15 interface dsl 0, interface ISDN Switchtype = primary-net5 Layer 1 Status: ACTIVE Layer 2 Sta...
Peter I called up the Telco and they confirmed that the data calls are also covered. Is there anything else at fault in the above configuration? Thank you for your support, really appreciate it...
