Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About rlongkd8fre
08-18-2017
rlongkd8fre
Member since
01-07-2013
Beginner
10
Posts
0
Helpful
0
Solutions
02-05-2013
06:37 AM
Christopher, Thanks. I'll try the blended mode and see if that's what I'm wanting. I majorly want the FXS phone for outbound calls and the ability to transfer a call to it, so I'm thinking that should work. Thanks, Russ
... View more
02-04-2013
12:24 PM
I have a system in Key Mode, and cannot seem to figure out how to get an analog phone that's plugged into the FXS Port to make an outgoing call.
... View more
Labels:
Created by
rlongkd8fre
in Voice Systems
in Voice Systems
02-04-2013
11:44 AM
02-04-2013
11:44 AM
Stephen: Have you troubleshot the line? Meaning, if you hook up a standard phone to the line, or another system, does it work? I'm betting that it might be a Provider issue.
... View more
01-09-2013
10:11 AM
Ok, regarding number 2... I have set it up as suggested, however, I see one problem. Incoming calls work as expected, and I can place them on hold and pick up from any extension, however, outgoing calls do not work as expected. When I place an outgoing call, it does not light up the shared extension button of the line in use, and therefore, an outgoing call placed on hold cannot be easily picked up from any extension. Russ
... View more
01-08-2013
11:53 AM
After talking with Mario, here are some updates: 1: appears to be a bad batch of phones, will be replacing one and testing, and will report back. 2: David's suggestion of using shared extensions and night service appears to be the best option, will be setting that up and testing tonight. 3: As previously stated, has been resolved using David and Mario's suggestions. --Russ
... View more
01-08-2013
06:13 AM
Daniel, On number 2, just so I make sure I'm thinking correctly, I would set up the CO lines to go to an operator with the destination being the shared extension in the Incoming Dial Plan area, and then setup night service on those shared extensions to call forward to the auto attendant?
... View more
01-07-2013
01:29 PM
I've got number 3 taken care of, following suggestions from Mario and Daniel. Still working on number 2. Daniel, your suggestion is along the lines of what I was thinking of. I'm trying to figure out the tricks to do it in CCA, but I'm not afraid of CLI either. -Russ
... View more
01-07-2013
12:59 PM
Just keeping this updated. Spoke with Mario on the phone. 1: System: 15.1(4)M4b Phones: SCCP 9.1.1.2.sr 2: We need to have the Line visablity and the ability to pick up any line on hold from any extension, hopefully without massive retraining of users. 3: I want to be able to connect via CCA to configure the system from any place on my LAN. Russ
... View more
01-07-2013
09:26 AM
I have installed and mainly configured my UC540 along with 8 of the 6961 Phones. I've now got a few questions, and cannot find answers to them. 1. Ringtones - On the phones, I can see the list of ringtones, but the softkeys to play and set them do not appear, just a back softkey. 2. AutoAttendant - I would like the system to act as though the 4 FXO lines are setup as CO Lines during the day, and then go to an autoattendant at night. (Right now, I'm manually switching the setup at open and close of business hours, which is obviously a pain) 3. Network Setup - At this location, I am unable to use the UC540 as my router, but I would like to have access to the system over the rest of the network. Right now, I have the WAN port connected to an extra port on my router, and have internet access from the Data VLAN, but cannot access the system from the rest of my existing LAN. Thanks, Russ
... View more
Labels:
02-05-2013 06:37 AM
Christopher,Thanks. I'll try the blended mode and see if that's what I'm
wanting. I majorly want the...
02-04-2013 12:24 PM
I have a system in Key Mode, and cannot seem to figure out how to get an
analog phone that's plugged...
Created by
rlongkd8fre
in Voice Systems
02-04-2013 11:44 AM
02-04-2013 11:44 AM
Stephen: Have you troubleshot the line? Meaning, if you hook up a
standard phone to the line, or ano...
01-09-2013 10:11 AM
Ok, regarding number 2...I have set it up as suggested, however, I see
one problem. Incoming calls w...
01-08-2013 11:53 AM
After talking with Mario, here are some updates:1: appears to be a bad
batch of phones, will be repl...
01-08-2013 06:13 AM
Daniel,On number 2, just so I make sure I'm thinking correctly, I would
set up the CO lines to go to...
01-07-2013 01:29 PM
I've got number 3 taken care of, following suggestions from Mario and
Daniel. Still working on numbe...
01-07-2013 12:59 PM
Just keeping this updated.Spoke with Mario on the phone.1: System:
15.1(4)M4b Phones: SCCP 9.1.1.2.s...
Public Statistics
| Date Registered | 01-07-2013 09:17 AM |
| Date Last Visited | 08-18-2017 03:56 AM |
| Total Messages Posted | 10 |
