Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am testing the following Flexible Netflow configuration on one of our ASR1001-X in the lab.
The router is running 3.14.0S:
flow record ipv4-netflow-record
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
m...
Hello!
I have setup L2 NetFlow on a Nexus 5696Q running 7.3(2)N1(1) code as follows:
feature netflow
!
flow exporter mac-netflow-export
destination 172.28.0.254 use-vrf management
transport udp 2055
version 9
!sampler mac-netflow-sampler
mo...
Hello.What i would like to accomplish is to limit the aggregate input bandwidth to let's say 1G, to a certain subset of vlans configured on a 6509-E. Bare in mind that this device is not doing L3 termination and thus, all ports are access ports. Belo...
Hello.Is there a way to monitor the laser levels (Tx, Rx) on non-DOM SFP equipped switch interfaces? I have tried sh int gigabitEthernet transceiver threshold table but this returns the expected values/thresholds, according to the SFP's manufacturer....
Hello.We are investigating a problem with unreasonably high CPU utilization, with one of our FWSM modules in a 6509-E. This is a newly implemented module with practically zero traffic passing through it but still, the CPU is at 20-22%. Here's some in...
To answer my own question, it seems that the source interface under the exporter configuration is required.
flow exporter mac-netflow-export
destination 172.28.0.254 use-vrf management
transport udp 2055
source mgmt0 !--- Missing command from o...
Hello.Please try the following for starters:! Define a ReadOnly Communitysnmp-server community RO! Define an IP Interface, sourcing the traps. Make sure you verify ip connectivity to the NMS Server, from this interface.snmp-server trap-source ! Defi...
Hello.In addition to what Mahesh suggested, please post the output of the show version command, while the routers are working and not while in rommon. This will probably help determine the reload reason.Hope this helps.
Hello.In order to obtain Cisco IOS images you need to have a valid CCO account. For that, it's best if you contacted your reseller for further details.
