Hi Sean, Further clarification with APNIC, this is their reply.... Does it meant, bit /33-47 is my main subnet And /48-/63 id customer's subnet and /64 is interface id or host in generally? +++++ For your own infrastructure, you can assign the IP as per your requirement. For your customers, you can only assign up to /48. If you need to assign more then /48 to your customers, you need to submit your APNIC second opinion request. +++++ Sent from Cisco Technical Support iPhone App ... View more

Hi Jeseph, Its very diffcult to try it using GNS (Dont know how to simulate using GNS), so I am trying to find a router to simulate it. What I want to achieve is to make the Cisco Router like Allot or Packeteer? I can control the bandwidth for particular subnet or IP address and assign CIR and BIR to them? Example; I allocated 10Mbps(upload and download) to 10.0.0.1 and they are allow to bursable to 20Mbps. Hope you understand what I want If you familiar GNS, can you also advise me how to do the test and what software I need to generate the traffic? Do i need to use two or more PC? Thanks you very much ... View more

Hi Giuseppe, Thanks for your reply, the option one look good. I tried using GNS to simulate this and below is the configuration on my Internet Router. I configured the ISP A and ISP B router to only propagate default route to my Internet Router (Router A & Router B) So from my router, I only received default route. On top of that, I configured HSRP on my router and a static route throw the independant IPv4 to Cisco ASA. And I configured a default route from Cisco ASA to HSRP VIP. Do you think my config correct? anything what can fine tune? Router A interface FastEthernet1/0 ip address 80.0.0.2 255.255.255.240 duplex auto speed auto standby 1 ip 80.0.0.1 standby 1 priority 110 standby 1 preempt delay minimum 60 standby 1 track Serial0 ! router bgp 65001 no synchronization bgp log-neighbor-changes network 40.0.0.0 mask 255.255.255.0 neighbor 100.1.1.1 remote-as 8001 neighbor 80.0.0.3 remote-as 65001 neighbor 80.0.0.3 next-hop-self no auto-summary ! ip route 40.0.01 255.255.255.0 80.0.0.5 RouterB interface FastEthernet1/0 ip address 80.0.0.3 255.255.255.240 duplex auto speed auto standby 1 ip 80.0.0.1 standby 1 preempt ! router bgp 65001 no synchronization bgp log-neighbor-changes network 40.0.0.0 mask 255.255.255.0 neighbor 200.1.1.1 remote-as 9001 neighbor 80.0.0.2 remote-as 65001 neighbor 80.0.0.2 next-hop-self no auto-summary ! ip route 40.0.0.0 255.255.255.0 80.0.0.5 ... View more

Thanks for your reply Joseph, I am still trying ... View more

Thanks Fsebera. I will try to explore more about this. Sent from Cisco Technical Support iPhone App ... View more

Hi Jonathan, Thanks for your reply. The port configuration just a normal trunk, no any Loop guard feature enable. But SW001 and SW004 have disabled STP gloablly. SW001and SW004 only allowed vlan 350 - 359 but SW002 and SW003 only allowed vlan 350 - 360 swithport mode trunk swithport allowed vlan 350-360 SW001 --> SW002 ---- SW003 <-- SW004 ... View more