Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello communityI installed version 2.8.1.5 and when I try an upload of the successfully discovered devices to cisco, it fails. The log file tail-end-gateway.log contains the following error:.....snip....message: uploadFileILB...message: Using the pro...
HelloIt there any feature in IOS to have multiple static port nat on the same port on outside pointing to different ports in the inside like in the following example?ip nat inside source static tcp 192.168.246.30 2025 172.23.198.30 25 route-map SRC-D...
Hellois it possible to assign different ip pools defined on the ACS to different NAS? For eg. I like to assign the IP pool x to the NAS X and the IP pool y to the nas Y. So if a user logins in to X he gets the pool x and on Y the pool y.thanks for an...
hellois it possible to disable a ipsec lan to lan tunnel with snmpset on a concentrator 3005? I found the following link http://www.cisco.com/warp/public/471/vpn3k_logout.html which shows how to terminate a tunnel.thanks for answers!Andre
HelloWe have a local network 10.1.1.0 and a remote network with 10.1.1.0 . If I connect with a vpn client 4.0.3D to a 3005 concentrator I can't reach the remote network. When I clear the local route with "route delete" in W2K on my client then I can ...
We have this problem as well with CSPC version 2.10.0.4 and 2.10.0.5, no serial number are displayed on the SNTC after a successful upload. serial number on CSPC exists for all devices.
This problem is a known issue. Please read CSCtf18476 at the following linkhttp://www.cisco.com/en/US/docs/net_mgmt/cisco_configuration_professional/v2_1/rlsnts/ccp_rel_notes.htmlcheersAndre
