This is a newbie question, I know, but I'm kind of newbie on this platform...Should I use a CAB-E1-RJ45BNC= to connect a UC560 T1/E1 port to a digital E1 trunk that is wired on Coax? or is there another part number for UC560?Thanks!
That has changed since then. According to this doc: http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750e_3560e/software/release/12-2_58_se/configuration/guide/scg3750e/swwccp.html
"Note Beginning with Cisco IOS Release 12.2(58)SE, both per...
Thank you all for your contributions! Marcus was right, I needed to first tell the UC560 to use the T1E1 port as E1 with 'card type e1 0 3' command. Then the UC560 told me this when I entered the ' ds0-group' config: %FREDDO_E1T1-3-NET_CLK_PARTICIPAT...
Thanks David, I would appreciate that very much!!Steven, I checked that reference guide and it doesn't mention anything about it.My doubt comes from the fact that I tried to get into the "config t -> controller e1" global configuration command to sta...
Thanks!Never imagined that such a newbie question would arise such a great flow of information!! Great answers guys! I'll have a great trouble on deciding which answer to mark as the solution to my question, since all are correct and of great help.Th...
Hi Marcos, Is it documented already? Where is it documented? I have this issue with some SPA504G and SPA525G2 Phones that partially localize to spanish the soft key labels and menus on a UC540. Can you tell me a little more detail on how to correct t...
