Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Trying to configurtie the cisco 4948e switch gigabitethernet port with "switchport trunk encapsulation dot1q", but didn't get the option. Please find below the options got after "swithport trunk"............SW(config-if)#switchport trunk ? allowe...
Hi,We have two 100 MBPS P2P link from two different ISP and we have terminated both the link on our 6509 switch. Now we want to configure the load balancing between these two disfferent ISP 100 MBPS P2P link.So, how to go and what all options we can ...
Hi All,Not able to ping a server directly connected from Switch via Patch Panel but able to see the MAC address of the same server under Switch MAC table. Also, the same server IP is pinging from other Switches as well on Network.Clear the ARP cache ...
Hi,We r using BGP on our MPLS rtr..now we have added new network on the existing BGP setup.....but unable to show the same under BGP table.router bgp xxxxx bgp log-neighbor-changes neighbor 10.X.X.185 remote-as XX55 ! address-family ipv4 neighbor 10...
Hi,We are having Cisco ACE 4710 K9 load balancer with version A3(2.7) on our environment. Now we have to migrate our Ipv4 network infrastructure to IPv6. So, can any one confim us that whether Cisco ACE 4710 K9 load balancer with our version is IPv6 ...
Hi Peter,I have got the interface capabilites information as suggested.4948 : SW3#sh interfaces g1/1 capabilitiesGigabitEthernet1/1 Model: WS-C4948-RJ-45 Type: 10/100/1000-TX Speed: 10,100,1000,auto...
Hi Peter,We have 4948 switch on our environment and where I am able to get the option of "Switchport trunk encapsulation dot1q" on interface. Please fine below the same for your reference.SW3#sh verCisco IOS Software, Catalyst 4500 L3 Switch Software...
Hi Marshall,I want to have that option "trunk enacpsulation dot1q" but on intreface of 4948e switch not getting the option "enacpsulation" after trunk.As a result not able to use the switch port as "trunk" port.Regards,Tuhin
Hi,Thanks for your information.FYI, both the linkn has been terminated on the same device only at remote end only as we are managing the remote end as well. Also, it is completely a L2 path.So, we have hard coded 100 MBPS full duplex both end for bo...
