Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Some background information of my current configuration. VLAN 100-Computer A interface gi1/1/1 IP:192.168.1.100 ACL: permit ip 192.168.1.100 255.255.255.255 192.168.2.100 255.255.255.255VLAN 200-Computer B interface gi1/1/2 ...
Hi,I had connected a computer and NTP to the SG500. i had successfullly sync the internet time on the computer. but when i type 'show clock' on the terminal. The switch did not manage to sync the ntp time. below is my config, am i short of anything e...
Hi,I will like to set auto baud for the SG500. By default its 115200bps.I had tried the following methods:1) switch xxxxx (config)# line console switch xxxxx (config-line)# autobaud --------------------> my terminal hangs and print out rubbish2) ...
Hi,I would like to communicate between VLAN, with some access control. I will like gi1/1/2 to be able to communicate with gi1/1/14 but not gi1/1/13.Some background information:VLAN 200gi1/1/1 -> computergi1/1/2-> NTPVLAN 300gi1/1/13 -> computergi1/1/...
Hi Tom,Unfortunately, upon pinging 192.168.2.255 from computer B. I have the following message."Reply from 192.168.2.1 bytes=32 time =1ms TTL=64"(192.168.2.1 is the IP of VLAN 200)And not any response from Computer C.Hope to do a boardcast so that ...
Hi Tom,Thank you for your response.I had configured the device(SG500) to be in layer 3, router mode. Please correct me if i am wrong, i thought the device is a switch + router. I have the SG500 connected directly to my NTP(gi1/1/2) and the computers(...
