Hi , I would like your feedback on what product to invest in. I am currently managing the network infrastructure for a small traveling company. The amount of people accessing the Internet during business hrs are between 30-40 active users, at peak times maybe as far as 50 users, probably more like maximum 70 users.These users are using the wireless for payments and conference over Internet So my plan is to have a good stable Cisco Router at the base, and the other Cisco Wireless Router which will act as repeater or Access Point  to get the wireless to cover the whole area. Can you please suggest what wireless routers can be used so that Router will work as Repeater as well. Or  Is it good to Use 2-3 Access Points with Wireless controller at base. Please let me know what Access Points and Wireless Controller will be good for our setup.   Please suggest which method is best for Wireless to work for 50 users effectively without any issues.   Lots of gratitude for having this support forum! Thanks, Prasad ... View more

Hi,   We want to configure WLC in such way that user with Lobby Admin privileges should authenticate through AD.   In other words , is there a way to configure a user account in AD which is used by the WLC for authentication that has only the privileges of Lobby admin (managing guest users)?   Thanks, Prasad ... View more

Hi, I am getting "User Access Filtered" error under Authentication Failure Code on ACS when i am trying to login to the device. Previously i was able to login but yesterday we made changes to switch by removing EIGRP and added some static routes after that we are not able to login to Switch but we can login to other devices configured on ACS. Thanks in advance... ... View more

Hi , I need a WCS report that will actually give me the top n Wireless Access points that have too many clients trying to authenticte to them. We have some serious capacity issue in meeting rooms but we need figure of how many WAPs might be affected.   I know I can interogate the WCS to drill down and find out that WAPs are exceeding their threshold I just need to have a decent report ... ... View more

Hi All, We have Cisco NCS device. I want to generate the report which will give me the information about DCA ( Dynamic Channel Allocation) for all Radio Channels ( i.e a/b/g/n) of all APs monitored by NCS. Does anyone has idea on how to generate this report? Thanks in Advance. Regards, Prasad ... View more

Hi , We have 1242-AG series AP which is configured in Rogue Detector mode. After adding this AP to WLC its showing Admin Status of AP as Down. When i am trying to enable the Admin Status its giving me following error " Admin status cannot be enabled for AP in Rogue Detector mode". Any suggestions on how to enable Admin Status for Rogue Detector AP. Thanks Prasad ... View more

Hi, We are having site to site VPN between our two sites. On each site we have multiple subnets and while monitoring on Cisco ASA we observed that there are two different tunnels been created i.e traffic is coming into our network through one tunnel and getting out of different tunnels this is what we observed on monitor tab of Cisco ASA. Please help Thanks Prasad ... View more

We have Cisco 1941 router and Cisco ASA 5540 firewall. We have VPN tunnel between ASA and Router.Router is behind the firewall and the peer IP of Router is NATed. Issue we are having is we are not able to browse the sites. If we adjust the MTU size on end devices we can browse some sites but its not allowing us to change the MTU size on Router Interface. Please suggest? Thanks, Prasad ... View more

Hi, I want to know how to take backup of Cisco Catalyst CE 500 series switch and restore the same. Regards, Prasad Bait ... View more

Hi, I want to know about the features of Universal K9 IOS. Regards Prasad bait ... View more