Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Hope someone can help me or point me in the right direction in regards to One-to-One NAT on the RV340.To put simply I'm wondering if anyone with experience in using the RV340 can confirm where a block of public IP addresses is in use and assum...
Hi Everyone,
Hoping someone can share some wisdom on an issue we have attempting to authenticate via the Guest Portal on a 5508.
We have a 5508 that was recently upgraded to 8.1.131.0, for a variety of reasons the WLC was factory defaulted and is n...
Hi,We have a site with a number of SG500X switches who are about to have a new server installed.The server is a Dell ESXi host with a dual port 10Gb NIC supporting SFP+.I know the primary purpose of the 10Gb ports on the SG500X is for stacking etc. b...
Hi All,I'm currently (pain-stakingly) trying to do what should be a simple task of upgrading a number of 7945's on a UC520.CCA is 3.3.2 and the UC520 on 8.6.The 7945's are on 8.3.2, Im trying to go to 8.5.2.Any attempt to drag and drop results in the...
Hi All,I have a strange issue I'm hoping someone can shed some light on.I have a CT2504 at a customer site which does not load the captive portal page correctly nor will it load via HTTP as opposed to HTTPS.So for starters I did what I do with all my...
My question is more of a pre sales question, I don't have a RV340 to test it on.The answer to the question will dictate whether I purchase and use an RV340 for our deployment. While I could buy one and see, time is restricted so I'd like to get the ...
Thanks again for your response.I'm afraid my question is still being misunderstood.Your example and info relates to incoming traffic, from public translated to private.I'm referring to traffic initiated and exiting the router, from private translated...
Hi balaji.band<>,Thanks for your response.I'm comfortable enough with the configuration so I'm not looking for a how-to, but it's appreciated anyway.So to be clear my question is not how do I configure One-to-One NAT, the focus is typically about inb...
I found the solution in the end, very simple one and was just a setting that was over looked.
Basically on version 8.1.131.0 on the 5508, at least in this instance, the default config has AAA>User Login Policies> Max Concurrent Logins for a user nam...
Hi Philip,
Thanks for your reply.
What I should of mentioned is prior to a clean config being applied, the WLC was running on its current version for some time without any issues being experienced with WebAuth. Only after being factory defaulted an...
